Hosted by

The intake of the GA16DNE engine has the TB in vertical position with the MAF attached to it, so, the GA16DE aftermarket parts doesn’t fit, because of that I will build a CAI with plastic tubes. By other side the good part is that the exhaust is the same only I will do is close the EGR output of the Header, next, the 2” stainless steel, mandel bents cat-back exhaust from Strömung Enginneering

11/21/2001 - HotShot Header Installation, My car doesn’t use oxygen sensor, but the ECU register the 33 error code, that means that the ECU is prepared to use it, so, I will find where it has to be connected to install it.